How To Clean Pentair Pool Filters

How To Clean Any Puddle Filter

Has your pool water turned cloudy, or are you worried it'due south most to?  So it's time to clean out that puddle filter!  Though the job may seem daunting at first, with intendance and attention, your pool filter can last for years; all it requires is a few minutes every few weeks and a fiddling chip of know-how.

Three of a Kind

There are three types of puddle filters usually in utilise, and information technology'southward of import to know which kind your puddle is using; cleaning these three dissimilar filters can exist markedly unlike. The three types of filters are:

Sand Filters

Cartridge Filters

Diatomaceous Earth (D.Due east.) Filters

• Sand Filters
  • The well-nigh affordable style.
  • Your pump pushes pool water through a tank approximately one-half-full of silica sand, which traps the particles and debris before passing the make clean water back into your puddle.
  • Sand filters are easy to maintain and long-lasting.
  • The primary drawback of sand filters is their effectiveness considering they aren't capable of trapping the smallest particles without the assistance of a filter help.

• Cartridge Filters
  • Effective and easy to maintain, cartridge filters are mid-tier pool filters.
  • Cartridge filters use a cylindrical fan-folded polyester cartridge as the filtering medium.  H2o flows through the fabric and traps droppings.
  • Cartridge filters are considered "light-green" filters because they tin can't be backwashed and, every bit a result, use less water when existence cleaned.
  • These filters can trap smaller particles.

• Diatomaceous Earth (D.Eastward.) Filters
  • Although the virtually expensive, D.E. filters are also the most effective, able to screen out all but the almost microscopic particles.
  • D.E. filters clean your water by passing it through a fine, white pulverisation that'southward actually made from the fossils of diatoms, a single-celled aquatic plant.
  • Just like a sand filter, D.E. filters can be backwashed.

DIY TIP: For any work on your pool filter, ever clothing recommended/required prophylactic equipment, and always follow the manufacturer's recommendations for cleaning, maintenance, and proper operation.  Never movement the backwash valve handle while the pump is operating, and — since the tank is pressurized — never open up the tank without opening the air relief valve and making certain the pump is off.

Cleaning a Sand Filter

TOOLS/SUPPLIES NEEDED

• Backwash hose
• Sand filter cleaner (Leslie's Sand Filter Revitalizer)
• Possessor's manual

Procedure FOR HOW-TO

Cleaning a sand pool filter is relatively like shooting fish in a barrel. You lot can backwash it, which you lot should do whenever it reaches 8-10 PSI over the normal operating level. Or you'll need to exercise it when the pool water gets cloudy.

At least twice a yr, you should chemically clean your sand
filter — with a cleaner that works — while backwashing the filter. Here'south how:

1. Showtime backwashing the filter to remove dirt and debris.
2. Slowly add the sand filter cleaner into the skimmer.
3. Aftermath the filter for 3 to five minutes again to remove clay and debris that has been dislodged by the filter cleaner.
4. When complete, turn off the filter pump. Move the backwash valve handle to the "Filter" position and turn the filter pump back on.
5. If y'all experience h2o-quality issues after chemically cleaning your filter or backwashing doesn't lower the psi because it may be time to change the sand.

Come across? Quick and easy! With sand filters, you tin can spend less time cleaning and more time enjoying your pool.

DIY TIP: If yous'd adopt to do a deeper cleaning, add a sand filter cleaner, such as Leslie'southward Sand Filter Revitalizer .  Follow the directions on the label and make sure the water level in the pool is correct prior to backwashing.

Cleaning a Cartridge Filter

TOOLS/SUPPLIES NEEDED

• Garden hose
• Spray nozzle
• Wrench fix (or equivalent)
• Filter cleaner
• Large saucepan (if needed)
• Non-petroleum-based lubricant
• Replacement O-ring (if needed)
• Replacement filter cartridges (if needed)
• Rubber mallet (for multi-element filters)
• Owner's manual

Procedure FOR HOW-TO

A cartridge filter is also easy to clean; yous just pull out the cartridges, clean them, and replace them. Only at that place are a few steps to follow to make sure information technology's done right.

1. Plough off your puddle pump at the breaker.
2. When the pump is off, remove air from the system by slowly opening the air-relief valve (usually located on tiptop of the filter) to remove whatsoever backlog air from the arrangement.
3. Remove the clamp or assembly holding the filter together. Your owner's transmission might come up in handy hither.
4. Remove the top of the filter.
5. Slowly and carefully remove the cartridges and set them aside. Inspect everything for damage and wearable. If yous discover any cracks or tears, or if a cartridge is mushy, information technology's time to replace the cartridge because information technology is no longer effective.
6. Make clean the cartridge using a spray nozzle on your garden hose. To do so, spray at an angle to get between the pleats. Never employ a pressure washer; it will damage the cartridges.
7. If the cartridge is really dingy, utilize a filter cleaner. Follow the manufacturer's instructions.
8. If the cartridge isreally, actually dirty, soak it in filter cleaner overnight. To do so, use a five-gallon bucket or make clean plastic trash can, and make sure the cartridges are completely submerged in the h2o and cleaner mixture.
9. Render the cartridges to the filter and secure them in place.
10. Replace the filter top and tighten the clench or assembly.
11. Next, check the O-ring on the filter tank. If it's in good shape, lightly utilise some lubricant to go along it that mode. If it's dry-rotted, deformed, stretched, or appears worn out, supervene upon it. Because clothing and tear are common, information technology'southward always a proficient idea to replace the tank O-ring at each cleaning.
12. Turn the system dorsum on and open the air-relief valve to release whatsoever excess air in the system. Keep the valve open until a steady stream of water sprays from it, then close.
13. Check the organization pressure to ensure it'southward in normal range. If the pounds per square inch (PSI) is off, you may take put the filter back together incorrectly, or something else may be wrong with the system. Troubleshoot the pool filter to identify and right the problem.

DIY TIP: You should clean your cartridge filters when the filter force per unit area estimate reading goes up 8-ten PSI above the clean starting force per unit area, or every 3-half-dozen months, depending upon the manufacturer'south recommendations. Cartridges tin last 3-4 years before needing to be replaced, based upon pool usage, water chemistry, and maintenance practices.

Manually Cleaning a D.E. Filter

TOOLS/SUPPLIES NEEDED

1. Aftermath hose
2. Garden hose
3. Diatomaceous earth (D.E.) filter cleaner
4. Lubricant
5. 5-gallon bucket
6. Large, plastic spoon for mixing D.E.
7. D.E. powder
8. D.E. Filter Cleaner
9. Rubber goggles
10. Dust mask
11. Acid-resistant gloves
12. Owner's manual

PROCESS FOR HOW-TO

Diatomaceous earth filters should be manually cleaned at least
twice a yr. The quickest, easiest method is to use D.East. filter cleaner.
Here's how to get started:

1. Backwash the filter for three to 5 minutes to remove dirt, debris and the one-time DE.
2. Turn the pump off and place the backwash valve dorsum in "Filter" mode.
3. Open the air relief valve.
4. Remove the drain plug, and permit the water drain out of the filter tank.
5. Remove the clamp or associates holding the filter together. If you lot're unsure how to open up it, bank check the owner'south manual.
6. Open up the filter tank by removing the tiptop one-half.
7. Rinse out the tank with the garden hose and reinstall the drain plug.
8. Clean the manifold and grids.
9. Utilize a spray nozzle on your garden hose to spray down the manifold, and make certain to thoroughly flush the grids of all droppings and used D.E.
10. If the grids are really dirty, use a D.East. filter cleaner. Follow the manufacturer's instructions and article of clothing safety equipment.
11. Audit the grids for tears or damage, and check the manifold for cracks.
12. Place the make clean grids back into the filter tank, line upward and install the manifold, and tighten the nuts. Exercise not overtighten. If there is a standpipe O-ring, replace it.
13. Lubricate the filter tank O-ring inside the tank and reinstall the top half of filter tank.
14. Add D.East. powder to the filter.
15. Refer to your filter owner's manual to determine how much D.Eastward. pulverization you'll need to add.
16. Commencement, in a clean bucket, mix the appropriate corporeality of D.E powder with plenty water to brand slurry, which is a sparse, flossy solution with the consistency of milk. Use the big plastic spoon to mix.
17. Prime number the filter pump by removing the strainer housing chapeau and filling the strainer housing with water; allow some water to run through the incoming line. As a upshot of use, you may need to lubricate the pump lid O-ring. Close the lid.
18. Open the filter air-relief valve to release excess air from the filter tank.
19. Turn on the pump and permit it run for 1-2 minutes to make sure y'all have full circulation.
20. Close the air-relief valve when water starts coming out.
21. While the pump is running, slowly pour the slurry directly into the pool skimmer.
22. Run the pool pump for at least 30 minutes to allow the D.Due east. to distribute evenly over the filter grids. Bank check for whatever D.E. returning to the puddle from the return line, and if you lot see whatever you may have a torn filigree, cracked manifold, or torn stem O-ring.

DIY TIP: Some cities have banned disposing of diatomaceous earth (D.E.) into the sanitary sewer organisation.  Contact your local water department for guidance.

And at that place you have it! Follow the steps for your respective filter
type to keep both your filter and your pool clean and clear.

Be sure to continue all necessary supplies on mitt then yous're always ready to clean your sand, cartridge, or diatomaceous earth filter equally presently every bit you notice information technology's not working properly.

---

Information technology's important for us to admit that certain aspects of pool care are subjective, based on personal preference. There are many variations of successful approaches, but we have devoted decades to honing our products and solutions. If yous have any questions, or if y'all retrieve information technology might be fourth dimension to replace your pool filter or filter media, stop byyour nearest Leslie's shop. Nosotros're here to help!

How To Clean Pentair Pool Filters,

Source: https://lesliespool.com/blog/how-to-clean-any-pool-filter.html

Posted by: fredericksbarpries.blogspot.com

Share this post